How Much Does Drywall Cost by Job?
A 14 x 12 ft room costs about $1,280 installed at $16 a sheet and $1.65 per sq ft of labor, a closet is set by the contractor's minimum charge rather than its 132 sq ft, and a repair is priced by the hours and return trips it takes.
Drywall cost depends on which job it is. A room is priced per square foot, a closet by the minimum charge, a repair by the visits, and all three move with the labor rate in your state.
| Page | Key figure | Default case |
|---|---|---|
| Whole room, installed | $1,280 for a 14 x 12 ft room | 21 sheets at $16, finishing supplies and labor at $1.65 per sq ft on 533 sq ft; enter your own rates |
| Closet | $400 labor on a 6 x 2.5 ft reach-in | 6 sheets and 132 sq ft; at $1.85 per sq ft the area price is below the $400 contractor minimum, so the minimum applies |
| Repair | priced by hours and visits | nail pops to a water-damaged ceiling: materials list, hours you can edit, and pro labor at the BLS median wage for your state |
| Labor by state | $0.76 per sq ft crew cost, US median | BLS median wage x 1.35 burden / 50 sq ft per labor hour; every state has its own figure and the ten largest markets their own page |
Drywall is cheap as a material and expensive as a trade: a sheet costs less than a pizza, but hanging, taping, three coats and sanding are skilled hours spread over several days. That is why the cost pages are split by job. The whole-room cost calculator prices board, finishing supplies and labor as separate lines so you can see which one a quote is high on. The closet page shows the minimum-charge logic that sets the price of any small job. The repair page counts hours and visits instead of square feet, because a doorknob hole and a water-stained ceiling share almost no steps. And the labor cost pages turn BLS wage data into a crew cost per square foot for every state, with the ten biggest markets broken down by metro.
What a per square foot price contains
The cost calculator's opening room shows the split. Of its $1,280 total, board is $336, finishing supplies $65 and labor $879: labor is most of the bill, and it is the line that changes with the state, the finish level and the ceiling height. The thickness comparison shows how little the board price moves even when you step up to 5/8 in type X.
Labor by state starts from what the installer is paid. The US median installer wage of $28.33 an hour, with 1.35 for payroll burden and 50 sq ft per labor hour to hang and finish, comes to $0.76 per sq ft of crew cost. A contractor's quote sits above that, because it also carries overhead, travel, profit and a minimum charge; the state pages show both numbers side by side.
Why small jobs cost more per square foot
Taping takes three coats on three days whether the job is a closet or a living room, so most contractors charge a minimum to come out. On the closet page's example the area price at $1.85 per sq ft is $245, which is below a $400 minimum, so the minimum is what you pay. The repair page is the same idea taken further: it prices the visits, and bundling several repairs into one visit is the single biggest saving on it.
Materials for any of these jobs come from the main drywall calculator, which lists sheets, compound, tape and screws for a room, and from the mud calculator when the finish level is the question.
