Skip to main content
DrywallPlanner

How Much Drywall for a Shed?

A 10 x 12 shed with 7 ft walls takes 17 sheets of 4x8 drywall with a vaulted ceiling and both gables boarded, and a 12 x 16 shed with 8 ft walls takes 23. Buy 19 and 26 to cover 10% waste.

Drywall for the two shed sizes people most often finish inside, laid out wall by wall with the gable triangles and the roof slope, plus the insulation that has to go in first.

Every page in this section, with the number its calculator opens on
PageSheets (4x8)Default case
10 x 12 ft shed, 7 ft walls17 sheets of 4x8, buy 19vaulted ceiling with both gables, 267 sq ft of wall after the door and a window
12 x 16 ft shed, 8 ft walls23 sheets of 4x8, buy 26vaulted ceiling with both gables, 397 sq ft of wall after the door and a window

A shed is a small job with two things a bedroom does not have: a vaulted ceiling that follows the roof, and gable triangles above the wall plates. Both shed pages start from a common build for that footprint, with a 6 in 12 roof, one window and the door the size that shed usually has, and lay every surface out in 4x8 board. The table above gives that default count for each size; each page also shows the smaller number for a flat ceiling at wall height, or for walls only, and what the same build takes in 4x12.

Why the vaulted ceiling costs the most board

The slopes of a gable roof are longer than the shed is wide, and the two gable triangles together equal one rectangle of the shed's width times the ridge rise. On the 10 x 12 shed that is 159 sq ft of ceiling and gable on top of 267 sq ft of wall. A flat ceiling at the plate is less board and easier to hang, but under 7 ft walls it takes away the headroom the vault was buying.

Hang the gables and the slopes first, then the walls, so the wall board supports the ceiling edges. Sheds framed 24 in on center need 5/8 in board or sag-resistant 1/2 in on the slopes; the thickness guide covers the joist-spacing rule.

Insulate before you board

Once the drywall is up the stud bays are closed, so insulation, wiring and any vapor control go in first. The shed insulation page counts batts bay by bay for the 10 x 12 build at 16 or 24 in framing, and the general insulation calculator handles any other size. A shed that will be heated also wants the rim and gable bays filled, which is where most of the batt count on a small building hides.

For a shed that stays unheated and unconditioned, think twice about drywall at all: board in a damp outbuilding sags and molds. The types guide covers mold-resistant panels for exactly this case, and the mud calculator sizes the compound once you have settled the board.